Customer Help Line
TEL: 1300 886 649
39
Operating the menus (Cont.)
Info
Press the INFO button to display or close program
information.
Record mode
Enter Record Mode via the Channel menu.
Mode:
every day, weekly, Auto.
Start Time: Set the date and time to start recording.
End Time: Set the date and time to end recording.
Important notes
When using the Media function, remember the following important points:
• We strongly recommend you back up all data in the USB storage device to another
storage device so you do not risk losing any data in case of an unexpected device
failure or accident. We do not assume liability for any loss of data due to misuse
or malfunction. Data backup is your personal responsibility.
• You cannot change to a channel from another broadcaster or select another func-
tion
while in recording mode.
• If the signal is interrupted or removed while in recording mode, the recording will
stop until the signal is established. This may cause you to lose program content.
• Do not turn the TV o
uring recording, otherwise the TV will exit the PVR function
and turn to standby mode.
• Th
recorded can only be used in this TV. Do not copy it to any other device.
• When you are in PVR recording mode, you may experience some di
culty with a
scheduled recording at di
erent times without removing the USB recording device.
You will need to remove the USB device as it is required to reset after each record-
ing to protect the device from damage. You may also see the message ‘DISK NOT
READY’ displayed. Remove the device, reconnect and proceed with your recording.
• Some USB storage devices may not be compatible for smooth operation with this TV.
• For lar
le sizes and large capacity storage devices, the loading speed may be longer.
• The recognition speed of a USB storage device may vary depending on the device.
• When connecting or disconnecting the USB storage device, ensure the TV is not in
Media mode, otherwise the USB device or th
les stored in it may be damaged.
• Only use a USB storage device formatted in a FAT
le system provided with the
Windows operating system. If it is formatted by a di
erent utility program that is
not supported by Windows, it may not be recognised.
• Ensure any USB devices connected to the TV do not use/exceed 500mA power rating.
• An “Unsupported File” message will be displayed if th
le format or codec is unsup-
ported or corrupted. (Refer to speci
cations table on page 40 for supported le types.)
To Next Page
Loading...
