GW Instek GDM-9060 - Page 298

GDM-906X Series User Manual
298
[SENSe:]VOLTage[:DC]:RESolution
Sets the DC Voltage measurement resolution. The resolution depends on
the rate and range settings.
Parameter: Resolution(<NRf> | MIN | MAX | DEF)
Example: SENS:VOLT:DC:RES MAX
Sets the DC Voltage resolution to MAX.
[SENSe:]VOLTage[:DC]:RESolution?
Returns the DC Voltage resolution.
[SENSe:]VOLTage[:DC]:TRIGger:DELay
Sets the trigger delay that minimum step is microseconds of DC Voltage
measurement.
Parameter: <NRf>(0 ~ 3600 s) | MIN | MAX | DEF
Example: SENS:VOLT:DC:TRIG:DEL MAX
Sets the trigger delay time to the maximum of DC Voltage measurement.
[SENSe:]VOLTage[:DC]:TRIGger:DELay?
Returns the trigger delay time in seconds of DC Voltage measurement.
Return parameter: <NRf>
[SENSe:]VOLTage[:DC]:ZERO:AUTO
Sets the auto zero mode to on, off or once of DC Voltage measurement.
Parameter: 0 | 1 | ON | OFF | ONCE
Example: SENS:VOLT:DC:ZERO:AUTO ONCE
Sets the auto zero to once.
[SENSe:]VOLTage[:DC]:ZERO:AUTO?
Returns the auto zero mode of DC Voltage measurement.
Return Parameter: 0 | 1, 1=ON, 0=OFF
[SENSe:]VOLTage:AC:BANDwidth
Sets the AC bandwidth (AC filter).
Parameter: <NRf> (3 | 20 | 200) | MIN | MAX | DEF
Example: SENS:VOLT:AC:BAND 20
Sets the AC bandwidth to 20Hz.
[SENSe:]VOLTage:AC:BANDwidth?
Returns the AC bandwidth.
Return parameter: <NRf>, Ex: 3.00000000E+00
[SENSe:]VOLTage:AC:NULL[:STATe]
Sets the relative function on/off for AC Voltage measurement.
Parameter: 0 | 1 | ON | OFF
Example: SENS:VOLT:AC:NULL:STAT ON
Turns the relative function on for AC Voltage measurements.
w ww. . com
information@itm.com1.800.561.8187