GW Instek GPP-2323 - Page 141

REMOTE CONTROL
141
Command
:DELAy[1|2]:STARt?
Function
Queries the sequence number for initial execution of
the channel delay output.
Example
:DELAy2:STARt?
Returns the initial sequence number of CH2 sequence
output.
Command
:DELAy[1|2][:STATe] {ON|OFF}
Function
Enable or disable the delay output function of the
active channel.
Description
{ON|OFF} Output state of the group
Example
:DELAy2 ON
Enable the delay output function for CH2.
Command
:DELA y[1|2] [:STATe]?
Function
Queries whether the output function of Delay has
been enabled or disabled.
Example
:DELAy2:STATe?
Return whether the output function of Delay has
been enabled or disabled for CH2.
Command
:DELAy[1|2]:STATe:GENErate {01P|10P}
Function
Selects the used pattern of the automatically
generated state.
Description
01P|10P
10P: the automatically generated state will repeat
by the sequence of Off and the On. The
automatically generated state will repeat by the
sequence of On and the Off.