GW Instek GPP-4323 - Page 174

GPP Series User Manual
174
Function
Query the DHCP status.
Example
:SYSTem:COMMunicate:LAN:DHCP?
Query the DHCP state.
Command
:SYSTem:COMMunicate:LAN:IPADdress
<IPaddress>
Function
Sets the IP address.
Description
<IP
address>
ASCII string, within the range of 1.0.0.0
to 223.255.255.255 (excluding
127.nnn.nnn.nnn).
Note: This command is only applicable if for the
manual IP mode. The
SYSTem:COMMunicate:LAN:APPLy command
needs to executed before the IP address settings can
take effect.
Example
:SYSTem:COMMunicate:LAN:IPADdress
172.131.161.152
Sets the IP address to 172.131.161.152.
Command
:SYSTem:COMMunicate:LAN:IPADdress?
Function
Queries the IP address.
Example
:SYSTem:COMMunicate:LAN:IPADdress?
Queries the IP address.
Command
:SYSTem:COMMunicate:LAN:SMASk <mask>
Function
Sets the subnet mask.
Description
<mask>
ASCII string, within the range of 1.0.0.0
to 255.255.255.255.
The SYSTem:COMMunicate:LAN:APPLy command
needs to be executed before the subnet mask setting
can take effect.