AC or DC Voltage input is strictly prohibited.
Discharge capacitor before testing
Do not place any heavy object on the
instrument.
When testing, the inductance should avoid
generating induced current, which may cause
damage to the instrument.
Avoid severe impact or rough handling that can
lead to damaging the instrument.
If the equipment is used in a manner not
specified by the manufacturer, the protection
provided by the equipment may be impaired.
(Note) EN 61010-1 specifies the measurement
categories and their requirements as follows.
The LCR-1000 Series doesn’t fall under category
II, III or IV.
Measurement category IV is for measurement
performed at the source of low-voltage
installation.
Measurement category III is for measurement
performed in the building installation.
Measurement category II is for measurement
performed on the circuits directly connected to
the low voltage installation.
To Next Page
Loading...
