GW Instek LCR-1100 - Measurement Parameter and Mode Commands

LCR-1000 Series
60
FUNC <C-D, C-Q, C-R, L-D, L-Q, L-R, L-Rdc, R-Q, R-X, R-Rdc,
Rdc, Z-D, Z-Q, Z-θr, Z-θd>
FUNC?
Function： It sets or queries the measurement parameters.
Description：
Set parameter <C-D|C-Q|C-R|L-D|L-Q|L-R|L-Rdc|R-Q| R-X|R-
Rdc|Rdc|Z-D|Z-Q|Z-thr|Z-thd>
Set syntax FUNC
Query syntax FUNC?
Return data <C-D|C-Q|C-R|L-D|L-Q|L-R|L-Rdc|R-Q|R-X| R-
Rdc|Rdc|Z-D|Z-Q|Z-thr|Z-thd>
Note
 When AUTO-LCZ is ON, after sending
FUNC command, AUTO-LCZ will be turned
off.
FUNC:EQU <SERIAL|PARALLEL>
FUNC:EQU?
Function： It sets or queries the equivalent mode.
Description：
Set parameter <SERIAL|PARALLEL>
Set syntax FUNC:EQU
Query syntax FUNC:EQU?
Return data <SERIAL|PARALLEL>
Note
 When AUTO-LCZ is ON, after sending
FUNC:EQU command, AUTO-LCZ will be
turned off.