LCR-8000G Series User Manual
134
≦10 kHz O/S Trimming Point List
The frequency of the extra trimming point is the measurement
frequency you were using before entering the calibration mode.
“O/S Trim Error!” warning will still appear after running a ≦10
kHz trimming if you choose to use a measuring frequency higher
than 10 kHz or other than where you were when you ran the ≦10
kHz trimming.
Spot Frequency O/S Trimming Point’s List
There is no extra trimming point if you choose to use Spot Freq. O/S
trimming.
“O/S Trim Error!” warning will still appear after running a spot
frequency trimming if you choose to use a measuring frequency
other than where you were when you ran the spot frequency O/S
trimming.
The frequency of the sole trimming point is the
very measuring frequency you were using before
entering the calibration mode.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
