GW Instek LCR-8101G - Measurement Item Description; Measurement Combination

LCR-8000G Series User Manual
38
Measurement Item Description
In general, two items, primary and secondary, are combined in a
single measurement. The following table shows the available
combinations. Overview of each measurement item is listed from
the next page.
Measurement combination
:Available, :Not available, :Combination doesn’t exist.
1st measurement
2nd measurement
Circuit model
Graph
*Prog
Q
D
RAC
G
Angle
Series
Parallel
Capacitance (C)
Inductance (L)
Reactance (X)
Susceptance (B)
Impedance (Z)
Admittance (Y)
DC Resistance(RDC)
Quality factor (Q)
Dissipation factor (D)
AC Resistance (RAC)
Conductance (G)
Angle (θ)
*Prog: Multi-step program
 The graph measurement is described in the Graph Mode chapter,
page88.
 The multi-step program mode is described in the Pass/Fail test
chapter, page71.
w ww . . co m
information@itm.com1.800.561.8187