GW Instek LCR-8101G - Hide Drive Voltage;Current

LCR-8000G Series User Manual
58
DC
AC≤
100Hz
AC≤
2kHz
AC>
2kHz
AC≥
1MHz
Slow
900ms
1.3s
600ms
600ms
620ms
Med
120ms
1.2s
470ms
450ms
470ms
Fast
60ms
650ms
180ms
150ms
150ms
Max
30ms
600ms
120ms
75ms
120ms
Beep setting
If the beep setting (page62) is active and
the display is in Pass/Fail test mode, it
might sound continuously depending
on the measurement result. If this
happens, press the Sing/Rep key and
set the mode to Single. Then turn Off
the buzzer.
Sing/Rep
Hide drive Voltage/Current
Background
The drive voltage and current shows
the actual voltage/current level
applied to the device under test.
Vm:549.8mV
Im:724.9pA
Panel operation
1. Press the Code key.

2. Enter the system code using the numerical
keys, then press the Enter key.
Hide drive V/I: 80

Vm:549.8mV
Im:724.9pA
Show drive V/I: 81

Vm:549.8mV
Im:724.9pA
w ww . . co m
information@itm.com1.800.561.8187