GW Instek LCR-8101G - Ass-Fail Mode; Pass-Fail Mode

PASS-FAIL MODE
59
PASS-FAIL MODE
In the Pass/Fail test mode, measurement results are
compared with user-defined limits and the results
are displayed. Two types of tests are available: Single
and Multi-Step. The Single test shares the same
interface with the basic measurement, and tracks one
item. The Multi-Step test runs a program comprised
of multiple measurement items with different
parameters.
Single-step
configuration
Overview ..................................................................... 61
Configure beep setting ............................................... 62
Configure the Average ................................................ 63
Select test item and scale (Pass/Fail test) ................. 64
Set parameters ............................................................ 65
Single-step run
Run in Absolute mode ................................................ 67
Run in Percentage mode ............................................ 68
Run in Delta mode ...................................................... 69
Use display value as nominal ..................................... 70
w ww . . co m
information@itm.com1.800.561.8187