GW Instek LCR-8101G - Graph Mode

LCR-8000G Series User Manual
32
Graph mode
Step
Description
Details
1. Connect fixture
Connect the fixture to the DUT.
Page24
2. Enter graph
mode
Press the Menu key, then F4 (Graph).
Page89
3. Select item
Press F5 repeatedly to select the graph
item.
Page90
4a. Set horizontal
scale (frequency)
Press the Up/Down key to move the
cursor to Sweep. Press the Left/Right key
to select Frequency. Then move the cursor
to Start Frequency, set the value using the
numerical and unit keys. Repeat this for
Stop Frequency and Level (drive
Voltage).
Page93
4b. Set horizontal
scale (voltage)
Press the Up/Down key to move the
cursor to Sweep. Press the Left/Right key
to select Voltage. Then move the cursor to
Start Voltage, set the value using the
numerical and unit keys. Repeat this for
Stop Voltage and Freq (frequency).
Page91
5. Select speed
Press the Up/Down key to move the
cursor to Speed. Press the Left/Right key
to select the measurement speed.
Page102
6. Select step size
Press the Up/Down key to move the
cursor to Step size. Press the Left/Right
key to select the data step (all or
sampled).
Page103
7. Select linear or
log scale
Press F1 (Lin/Log) to select linear or
logarithmic horizontal scale.
Page92
8a. Set vertical
scale (Absolute +
Auto fit)
Press F2 (Abs/%) to select Abs, then press
F3 (Manual/Auto fit) to select Auto fit.
the LCR-8000G automatically configures
the vertical scale.
Page99
w ww . . co m
information@itm.com1.800.561.8187