GW Instek LCR-8101G - Page 33

GETTING STARTED
33
8b. Set vertical
scale (Absolute +
Manual fit)
Press F2 (Abs/%) to select Abs, then press
F3 (Manual/Auto fit) to select Manual fit.
Move the cursor to Hi, set the Hi value.
Repeat this for Lo as well. The minimum
and maximum vertical range is manually
configured.
Page95
8c. Set vertical
scale (Percentage
+ Auto fit)
Press F2 (Abs/%) to select %, then press
F3 (Manual/Auto fit) to select Auto fit.
Move the cursor to Nominal and set the
nominal value. The LCR-8000G
automatically configures the vertical
range around the nominal value.
Page100
8d. Set vertical
scale (Percentage
+ Manual fit)
Press F2 (Abs/%) to select %, then press
F3 (Manual/Auto fit) to select Manual fit.
Move the cursor to Hi, set the Hi
percentage. Repeat this for Lo and
Nominal. The minimum and maximum
vertical range is manually configured.
Page97
9. Plot graph
Press F4 (Start). The graph is drawn on
the display. To abort, press F6 (Abort).
Page104
10. Fit graph into
display
When plotting is finished, press F1
(Function), then F2 (Fit). The vertical scale
is automatically adjusted to include all
the plotted line. Press F1 (View) to go
back.
Page106
11. Move marker
Press the Left/Right keys to move the
marker on the graph. To move the marker
to the peak, press F1 (Function) and F3
(Peak). To move to the dip, press F4 (Dip).
Press F1 (View) to go back.
Page107
12. Return to
previous menu
Press F6 (Return) or press the Menu key
to go back to the previous or the other
menu.
Page107
w ww . . co m
information@itm.com1.800.561.8187