GW Instek LCR-8101G - Tutorials (Step by Step Operations); Tutorial Basic Measurement (Without Pass;Fail Test)

LCR-8000G Series User Manual
26
Tutorials (Step by Step Operations)
Basic measurement (without Pass/Fail test)
Step
Description
Details
1. Connect fixture
Connect the fixture to the DUT.
Page24
2. Enter menu
Press the Menu key, followed by F1 (AC
measurement) or F2 (Rdc).
Page48
3. Hide scale
Press F4 (Show/Hide Scale) to hide the
scale (or show the circuit diagram)
Page50
4. Select measur-
ement item
Press F1 (First) and F2 (Second)
repeatedly to select the measurement
item.
Page51
5. Select series/
parallel circuit
If available, press F3 (Series/Parallel) to
select the equivalent circuit model.
Page51
6. Set
measurement
frequency
Press the Left/Right arrow key and move
the cursor to the Frequency. Use the
numerical and unit keys to set the
frequency.
Page53
7. Set
measurement
Voltage
Press the Left/Right arrow key and move
the cursor to the Voltage. Use the
numerical and unit keys to set the level.
Page55
8a. Select Single
measurement
Press the Sing/Rep key to select Single
(manual trigger) measurement. To trigger
measurement, press the Trig key.
Page56
8b. Select
Repetitive
measurement
Press the Sing/Rep key to select
Repetitive (automatic trigger)
measurement. Press the Left/Right arrow
key and move the cursor to Speed. Press
the Up/Down key to select the speed.
Page57
w ww . . co m
information@itm.com1.800.561.8187