GW Instek LCR-8101G - Page 92

LCR-8000G Series User Manual
92
Unit Mismatched
If a value outside of the range is entered, the
closest available value is automatically selected.
Nearest Available
If the entered start Voltage level is higher than
the stop Voltage, the two values are swapped.
Hi and Lo Swapped
Set stop Voltage
4. Repeat the above step for the stop Voltage.
Stop:1.00 V
Range
10mV ~ 2V (AC≤3 MHz)
10mV ~ 1V (AC>3 MHz) *1mV step
(Stop Voltage must be higher than the Start
Voltage)
Set measurement
Frequency
5. Use the Up/Down key to move the
cursor to Frequency setting (Freq).
Freq : 10.000kHz
Use the numerical keys to enter the
measurement frequency.
Range
20Hz ~ 1MHz/5MHz/10MHz
50Hz
Enter
1MHz
M
Enter
Backspace
All clear
Clear
Select Lin/Log
scale
6. Press F1 to select the horizontal
scale, Linear or Logarithmic.
Log(V)Lin(V)
F 1
w ww . . co m
information@itm.com1.800.561.8187