GW Instek PSU 100-15 - System:communicate:serial[:Receive]:Transmit:parity

PSU Series Programming Manual
124
Syntax
Query Syntax
:SYSTem:COMMunicate:SERial[:RECeive]:TRANsmit
:BITS <NR1>
:SYSTem:COMMunicate:SERial[:RECeive]:TRANsmit
:BITS?
Parameter/Return
parameter
<NR1>
0
7 bits
1
8 bits
Example
SYST:COMM:SER:TRAN:BITS?
>1
Indicates that 8 data bits are used for the UART
connection.
SYST:COMM:SER:TRAN:BITS 1
SYST:REB
Set the UART data bits to 8 data bits and reboot
the unit to active the setting.
:SYSTem:COMMunicate:SERial[:RECeive]
:TRANsmit:PARity
Set
Query
Description
Sets or queries the parity of the UART connection.
Note
The setting will only be valid after the power has been
cycled.
Syntax
Query Syntax
:SYSTem:COMMunicate:SERial[:RECeive]:TRANsmit
:PARity <NR1>
:SYSTem:COMMunicate:SERial[:RECeive]:TRANsmit
:PARity?
Parameter/Return
parameter
0
None
1
Odd
2
Even