H3C S5500-EI Series Installation Manual

1-14
LED Status Description
Steady green
Hot swappable power module slot 2 is installed with a power
module, and the power output is normal.
Steady yellow
Hot swappable power module slot 2 is installed with a power
module, but an output failure occurs.
PWR2
Off
No power module is installed in hot swappable power
module slot 2, or no power is input.
RPS Status LED
The RPS status LED helps you determine the working status of the RPS of the switch. Refer to Table
1-9 for details.
Table 1-9 RPS status LED
LED Mark Status Description
Steady green
The AC input is normal, and the RPS is in the
position or works normally.
Steady yellow
The RPS input is normal, but the AC input fails or
is not connected.
RPS status LED
(S5500-28C-EI and
S5500-52C-EI)
RPS
Off RPS is not connected.
Steady green
The -48V DC input is normal, and the RPS is in the
position or works normally.
Steady yellow
The RPS input is normal, but the -48V DC input
fails or is not connected.
RPS status LED
(S5500-28C-EI-DC)
RPS
Off RPS is not connected.
Steady green
The RPS input is normal, and the AC input works
normally.
Steady yellow
The RPS input is normal, but the AC input fails or
is not connected.
RPS status LED
(S5500-28C-PWR-EI
and
S5500-52C-PWR-EI)
RPS
Off The RPS input is abnormal.
Port Mode LED
The port mode LED on the S5500-EI series can display the working status of a port for you to obtain
more device information. You can use the port mode switching button to change the status of the port
mode LED.
Table 1-10 Port mode LED description
LED Status Description
Steady green Indicates port rate.
Flashing green (1 Hz) (supported by
PoE switches only)
Indicates port PoE power supply.
Mode
Steady yellow Indicates port duplex mode.

H3C S5500-EI Series Specifications

General

Brand	H3C
Model	S5500-EI Series
Category	Switch
Language	English