4-9
# Mark the HTTP traffic of the management department, marketing department, and R&D department
to the Internet with 802.1p priorities 4, 5, and 3 respectively. Use the priority mapping table configured
above to map the 802.1p priorities to local precedence values 6, 4, and 2 respectively for differentiated
traffic treatment.
# Create ACL 3000 to match HTTP traffic.
[Device] acl number 3000
[Device-acl-adv-3000] rule permit tcp destination-port eq 80
[Device-acl-adv-3000] quit
# Create class http and reference ACL 3000 in the class.
[Device] traffic classifier http
[Device-classifier-http] if-match acl 3000
[Device-classifier-http] quit
# Configure a priority marking policy for the management department and apply the policy to the
incoming traffic of GigabitEthernet 2/0/3.
[Device] traffic behavior admin
[Device-behavior-admin] remark dot1p 4
[Device-behavior-admin] quit
[Device] qos policy admin
[Device-qospolicy-admin] classifier http behavior admin
[Device-qospolicy-admin] quit
[Device] interface gigabitethernet 2/0/3
[Device-GigabitEthernet2/0/3] qos apply policy admin inbound
# Configure a priority marking policy for the marketing department and apply the policy to the incoming
traffic of GigabitEthernet 2/0/1.
[Device] traffic behavior market
[Device-behavior-market] remark dot1p 5
[Device-behavior-market] quit
[Device] qos policy market
[Device-qospolicy-market] classifier http behavior market
[Device-qospolicy-market] quit
[Device] interface gigabitethernet 2/0/1
[Device-GigabitEthernet2/0/1] qos apply policy market inbound
# Configure a priority marking policy for the R&D department and apply the policy to the incoming
traffic of GigabitEthernet 2/0/2.
[Device] traffic behavior rd
[Device-behavior-rd] remark dot1p 3
[Device-behavior-rd] quit
[Device] qos policy rd
[Device-qospolicy-rd] classifier http behavior rd
[Device-qospolicy-rd] quit
[Device] interface gigabitethernet 2/0/2
[Device-GigabitEthernet2/0/2] qos apply policy rd inbound
To Next Page
Loading...
Need help?
General
