9
3. Decompress the installation package to obtain the StorCLI tool package for different operating
systems.
Installing StorCLI
See the release notes to install StorCLI for the corresponding operating system.
Commonly-used commands in StorCLI
This section describes the usage and examples of commonly used commands in StorCLI. You can
use StorCLI commands to manage storage controllers during normal server operation without
restarting the server.
All commands in StorCLI related to specifying paths do not support spaces or special characters.
Viewing the storage controller configuration
Perform this task to view storage controller information, including storage controller name, firmware
version, drive slot, capacity, vendor, serial number, interface type, and interface speed.
Syntax
./storcli64 /ccontroller_id show
Parameters
controller_id: Specifies the controller ID. To view information about all storage controllers,
specify the controller ID as
all.
Examples
# View storage controller configuration.
[root@localhost storcli]# ./storcli64 /c0 show
CLI Version = 007.1207.0000.0000 Sep 25, 2019
Operating system = Linux 4.18.0-193.el8.x86_64
Controller = 0
Status = Success
Description = None
Product Name = HBA 9400-16i
Serial Number = SPB2726571
SAS Address = 500605b01193f2e0
PCI Address = 00:41:00:00
System Time = 03/21/2020 00:05:20
FW Package Build = 00.00.00.00
FW Version = 17.00.00.00
BIOS Version = 09.33.00.00_17.00.00.00
NVDATA Version = 17.01.00.25
PSOC Version = 06000001
Driver Name = mpt3sas
Driver Version = 32.100.00.00
Bus Number = 65
To Next Page
Loading...
Need help?
General
