118
Creating an IPv6 static route
1. Select Network > IPv6 Routing from the navigation tree.
2. Click the Create tab to enter the IPv6 static route configuration page, as shown in Figure 120.
Figure 120 Create an IPv6 static route
3. Specify relevant information as described in Table 56.
4. Click Apply.
Table 56 Configuration items
Item Descri
tion
Destination IP Address
Enter the destination host or network IP address, in the X:X::X:X format.
The 128-bit destination IPv6 address is a hexadecimal address with
eight parts separated by colons (:). Each part is represented by a
4-digit hexadecimal integer.
Prefix Length
Enter the prefix length of the destination IPv6 address.
Preference
Set a preference value for the static route. The smaller the number, the
higher the preference.
For example, specifying the same preference for multiple static routes
to the same destination enables load sharing on the routes, while
specifying different priorities for them enables route backup.
Next Hop
Enter the next hop address, in the same format as the destination IP
address.
To Next Page
Loading...
