H3C WA2610E-AGN - Enabling the DHCP Server on an Interface; Display the Information of Assigned IP Addresses

129
Item Descri
p
tion
Gateway Address
Enter the gateway addresses for the client.
DHCP clients that want to access hosts outside the local subnet
request gateways to forward data. You can specify gateways in
each address pool for clients and the DHCP server assigns
gateway addresses while assigning an IP address to the client.
Up to eight gateways can be specified in a DHCP address pool,
separated by commas.
DNS Server Address
Enter the DNS server addresses for the client.
To allow the client to access a host on the Internet via the host
name, you need to specify DNS server addresses.
Up to eight DNS servers can be specified in a DHCP address
pool, separated by commas.
WINS Server Address
Enter the WINS server addresses for the client.
If b-node is specified for the client, you do not need to specify any
WINS server address.
Up to eight WINS servers can be specified in a DHCP address
pool, separated by commas.
NetBIOS Node Type Select the NetBIOS node type for the client.
Enabling the DHCP server on an interface
1. Select Network > DHCP from the navigation tree to enter the default DHCP Server page shown
in Figure 126.
2. C
lick the icon next to a specific interface to enter the page shown in Figure 129.
3. Selec
t the Enable option for DHCP Server.
4. Click Apply.
Figure 129 Configure a DHCP server interface
Display the information of assigned IP addresses
1. Select Network > DHCP > DHCP Server from the navigation tree to enter the page, as shown
in Figure 126.
2. View the information abou
t the IP address assigned from the address pool in the Addresses In Use
field.