H3C WA2610E-AGN - Configuring Channel Detection; Displaying Detection Record

190
Figure 185 Setting AP operating mode
3. Configure the AP operating mode as described in Table 76.
4. Click Apply.
Table 76 Configuration items
Item Descri
p
tion
Work Mode
Set the AP operating mode:
• Normal—The AP only provides WLAN data services.
• Monitor—The AP only scans all 802.11 frames in the WLAN.
• Hybrid—The AP can both scan devices in the WLAN and provide WLAN
data services.
IMPORTANT:
• When an AP has its operating mode changed from normal or hybrid to
monitor, it does not restart.
• When an AP has its operating mode changed from monitor to normal or
hybrid, it restarts.
NOTE:
• If an AP operates in hybrid mode, you must configure WLAN service so that the AP can both scan
devices in the WLAN and provide WLAN data services.
• If an AP operates in monitor mode, the AP does not need to provide WLAN data services and you do
not need to configure WLAN service.
Configuring channel detection
Displaying detection record
Select Radio > Channel Detection from the navigation tree, and you will enter the Detect Record tab.