56
Item Descri
tion
IPv6 Config
Set the way for the interface to obtain an IPv6 link-local address, including:
•
None: Select this option if you do not want to assign an IPv6 link-local address
to the interface.
•
Auto: Select this option for the system to automatically assign an IPv6 link-local
address to the interface.
•
Manual: Select this option to manually assign an IPv6 link-local address to the
interface. If this option is selected, you must set the IPv6 Link Local Address
field.
IPv6 Link Local Address
If the Manual option is selected as the way for the interface to obtain an IPv6
link-local address, you must set an IPv6 link-local address for the interface.
Modifying a Layer 2 interface
1. Select Device > Interface from the navigation tree.
The page in Figure 49 appears.
2. Click the icon corresponding to a Layer 2 interface
The page for modifying a Layer 2 interface appears.
Figure 52 Modify a Layer 2 physical interface
3. Modify the information about the Layer 2 physical interface as described in Table 29.
4. Click Apply.
To Next Page
Loading...
