EasyManua.ls Logo

Häfele FT 200 - Page 13

Häfele FT 200
41 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HDE 04.10.2021 732.22.024
52
Keyed to differ operation
An authorised user key simultaneously unlocks only certain locks, even though several are
connected to the FT 200 / FT 200 CAP furniture terminal, and also the MLA 6P / MLA 8 multi-
lock adapters if necessary.
Lock allocation can take place in two different ways:
by presenting the programming key card
several times8.4.1 Allocating user keys by
means of consecutive lock allocation, page 66
by unlocking the locks
8.4.2 User key allocation by unlocking the locks, page 68
Latchbolt lock operation / self-locking action (= factory setting)
In latchbolt lock operation, the locks are unlocked during the open time. The locks then lock
automatically once the open time has elapsed (self-locking action).
Deadbolt lock operation (permanent open)
In latchbolt lock operation, all locks are permanently unlocked during the open time
(permanent open). The locks are locked by presenting one of the user keys that is authorised
for deadbolt lock operation again.
Deadbolt lock operation can be enabled in two ways:
With appropriately programmed user keys
6.3 Programming a user key with deadbolt lock
function, page 61
By setting the FT 200 / FT 200 CAP furniture terminal to permanent deadbolt lock operation
8.3 Programming permanent deadbolt lock operation, page 65
Permanent deadbolt lock operation is then enabled for all locks and all authorised user keys.
It is deactivated by re-entering an open time (
8.5 Adjusting the open time, page 69) or by
means of a complete reset (
12.2 Complete reset, page 78).
Operation with 2 antennas
Operation with 2 antennas can take place in two ways:
operation mode Description
Parallel operation (standard) Same functionality at both antennas
Separate operation (macro) The EFL 3 / EFL 3C outputs on the FT 200 / FT 200 CAP
(or on the MLA 8 / MLA 6 P multi-lock adapters) can be allocated
separately to both antennas. In this way, they can be operated
independently of each other via antenna 1 or antenna 2.
A macro is required for this application.
ins-src-732.22.024.book Seite 52 Mittwoch, 13. Oktober 2021 1:58 13

Table of Contents