RE 15409, Version 08.2022, Bosch Rexroth AB
Installation | CMp 53/64
7.3.3 Water content sensor
The water content sensor should be mounted after the cooler hose which leads
the cooled oil back to tank. Recomendation to use the interface towards the
coupling which is mounted in the beam, inside or outside the drive unit:
• Outside the drive unit, easier to mount, but harder to utilize the “roads” inside
the cabinet for cabling.
• Inside the drive unit, easier to access the “roads” but harder to mount the sensor.
This choice should be taken on site by Bosch Rexroth personel.
For Hägglunds DUc (see Fig. 60) chose one of the two spots where it makes easier
to mount cable in a correct way.
Fig. 59: Recommended mounting position in Hägglunds DUe
Fig. 60: Recommended mounting position in Hägglunds DUc
42612
42614
To Next Page
Loading...