Hakko Electronics FM-203 User Manual

黒
白
D
S
Dch
Sch
基板/温調用
コネクタ基 板
電源
スイッチ
イ ン レ ット
14.配線図
High-output, temperature controlled
Soldering station
Instruction Manual
●
Thank you for purchasing the HAKKO FM-203 soldering station.
Please read this manual before operating the HAKKO FM-203.
Keep this manual readily accessible for reference.
●
TABLE OF CONTENTS
1. PACKING LIST AND PART NAMES ................................. 57
2. SPECIFICATIONS ........................................................... 58
3. WARNINGS, CAUTIONS, NOTES AND EXAMPLES .................. 59
4. INITIAL SETUP ................................................................ 60
5. OPERATION ................................................................... 62
6. PARAMETER SETTINGS ................................................. 68
7. MAINTENANCE .............................................................. 72
8. ERROR MESSAGES ....................................................... 74
9. TROUBLE SHOOTING GUIDE ........................................ 75
10. PARTS LIST .................................................................... 77
11. TIP STYLES .................................................................... 79
12. OPTIONAL PARTS LIST .................................................. 81
13. WIRING DIAGRAM .......................................................... 83
English
中文 日本文
日本文 中文
English

Hakko Electronics FM-203 Specifications

General

Brand	Hakko Electronics
Model	FM-203
Category	Soldering Gun
Language	English

Summary

1. PACKING LIST AND PART NAMES

2. SPECIFICATIONS

3. WARNINGS, CAUTIONS, NOTES AND EXAMPLES

4. INITIAL SETUP

A. Iron holder

Instructions for assembling and operating the iron holder, including tip cleaning.

5. OPERATION

Controls and displays

Overview of the HAKKO FM-203 controls and their functions, including buttons and display elements.

Replacing the tip

Removing the tip

Detailed steps for safely removing the soldering tip from the connector assembly.

Inserting the tip

Detailed steps for securely inserting the soldering tip into the sleeve assembly and connector.

6. PARAMETER SETTINGS

Parameter entry mode process

Step-by-step guide for entering the parameter entry mode and setting parameters.

7. MAINTENANCE

Tip maintenance

Procedures for maintaining soldering tips, including temperature, cleaning, and after-use care.

Checking Procedure

Check for a broken heater or sensor

Procedure to measure resistance for heater/sensor integrity and identify potential breakage.

Checking the connection cord for breakage

Procedure to check the connection cord for breakage by measuring resistance.

8. ERROR MESSAGES

Sensor Error

Explanation of the 'S-E' error message indicating a sensor or heater failure.

Low-temperature alarm tolerance error

Heater terminal short circuit error

Soldering iron error

9. TROUBLE SHOOTING GUIDE

The unit does not operate when the power switch is turned on.

Troubleshooting steps for when the unit fails to power on.

The tip does not heat up.

Troubleshooting steps for when the soldering tip does not heat up.

Solder does not wet the tip.

The tip temperature is too high.

The tip temperature is too low.

The soldering iron error [-E is displayed.