Hamer 525WT - SETTING UP THE MODEL 525 WIRE TIE MACHINE; INSTALLING A ROLL OF POLYETHYLENE FILM

Rev.7 9
SETTING UP THE MODEL 525 WIRE TIE MACHINE
FIGURE 3
INSTALLING A ROLL OF POLYETHYLENE FILM
1. Release the Lock Knob and pull up on the core shaft, removing the core holder from the cardboard tube of
the previous roll of film.
2. Lift up on the pivot bar so you clear the lock pin, then swing the pivot bar out to the side of the machine
and allow the bar to lock at that position.
3. Install the new roll of polyethylene film on the hub of the roll holder.
4. Return the pivot bar to the original position over the center of the film roll and lower the core holder into
the cardboard tube maintaining a loose fit in the tube, then tighten the lock knob onto the core shaft.
• Note: See “Adjustments” for raising or lowering the roll holder.