Hamilton Microlab STAR - Page 79

Microlab
®
STAR User Manual
610766/02 Page 79 of 225
- “Copy pattern” means that in case of an error on aspiration, the corresponding well of the
dispense sequence will be left out (the pattern is kept). If “copy pattern“ is not checked,
the dispense sequence positions will all be pipetted, leaving an unpipetted well at the end
of the sequence.
- “Exclude error positions” means exclude the erroneous positions from aspiration and
dispense sequences. If this option is enabled and an error occurs during an aspirate or
dispense step, the erroneous position will be excluded from the sequence by removing
the corresponding element from the aspirate or dispense sequence. The next time these
sequences are used, the erroneous well will not be pipetted.
In addition, ZDONDZD\mode can be enabled. If this checkbox is checked, a timeout has to
be specified, after which the error dialog on runtime will automatically close down again to
continue with the selected error handling: Abort, Cancel, or default error recovery.
127(
([FHSWLRQ,IWKHRSWLRQ³GHIDXOWHUURUUHFRYHU\´LVFKRVHQDQGDQHUURURFFXUVIRUZKLFKWKH
GHIDXOWLVVHWWRDERUWHJDKDUGZDUHHUURUWKHZDONDZD\PRGHLVOHIWRQDQGWKHGLDORJ
ZDLWVIRUXVHULQWHUDFWLRQ7KHRWKHUGHIDXOWVHWWLQJVFRUUHVSRQGWRWKRVHRIWKHVLQJOHVWHSV
VHHFKDSWHUIRUIXUWKHUH[SODQDWLRQVRIZDONDZD\HUURUKDQGOLQJ
Copy
Copy
Copy Pattern
Checked
Copy Pattern
NOT Checked