Handiquilter ProStitcher Lite - Installation on the HQ Loft Frame; Install the Flexirack on the HQ Loft Frame

18 | Pro‑Stcher Lite for the HQ Simply Sixteen www.ProStcher.com
Installaon on the HQ Lo Frame
Install the Flexirack on the HQ Lo Frame
(For installaon instrucons on the HQ Lile Foot
Frame, go to page 23.)
Locate the blue 10‑foot Flexirack (see Parts List,
item B) and your carriage with the Pro‑Stcher Lite
tray assembly mounted.
 NOTE: Unroll and straighten the blue
Flexitrack allowing it to relax so it will be
easier to lay it onto the table top.
 IMPORTANT: Looking at the boom side of
the tray/carriage assembly, ensure the black
discs are in the engaged posion. The black
discs are engaged when the round part of
the eccentrics are on the X and Y levers. The
black discs are disengaged when the at part
is on the levers. Rotate the black discs by
hand as needed to engage them with the
black gears.
1. Place the carriage on the frame, aligning wheels
with the tracks, with the carriage encoder and
power cord receptacle at the rear of the frame.
engaged round
on levers
front
rear