Handiquilter ProStitcher Lite - Page 21

20 | Pro‑Stcher Lite for the HQ Simply Sixteen www.ProStcher.com
5. Trim the Flexirack to length using a knife or wire
cuers. The blue Flexirack does not need to
extend the full width of the table and can be a
couple of inches shorter on either end.
6. At both ends of the blue Flexirack, use two of
the small metal clamps (see Parts List, item C) to
hold the ends rmly in place. The clamps have
a hole through the center and a bent lip on one
end. The lip should be on the side opposite the
blue Flexirack. Place the clamps where they
will be aached and drill pilot holes using the
3/32‑inch drill bit (see Parts List, item D) and
then use a Phillips screwdriver to fasten the
clamps on both sides of the Flexirack to the
table.
Next, skip to the Y-rack alignment step on page 28.