Handiquilter ProStitcher Lite - Warranty; Pro-Stitcher Lite Limited Warranty Terms

Pro-Stcher Lite for the HQ Simply Sixteen Installaon Instrucons | 43
Problem/Symptom Correcve Measure
Error messages
Buer Underow If a message with the words "Buer Underow"
appears while stching, it is an indicaon that data is
not geng to the motors quickly enough. This may be
due to something in the tablet computer tying up the
CPU. Although it may be possible to resume quilng by
simply pressing the red X box to close the error message
and then pressing the Motor Error lightning bolt buon
at the top right‑hand corner of the screen, it is best to
cancel the current design stch‑out, save the paern,
and reboot the computer. Use the New Start Point
funcon if necessary to resume from where stching
was le o.
System Restore or System Repair message on
start‑up.
If a message appears on start‑up (black screen, white
text) that asks whether to run System Restore or Start
Windows Normally, select Start Windows Normally.
The system should resume as normal. The computer
will default to the System Restore screen (more of a
typical Windows blue/white screen) if you do not select
the Start Normally opon in me. If this occurs, use the
power switch to reboot the computer and try again.