disconnect the electric appliances from the
battery.
If the forklift truck needs to be restarted, the
emergency power-off switch should be
toggled.
Turn off the emergency power-off switch 30s
after shutdown.
Hand brake lever [15]
Pull the lever back to engage and push the
lever forward to release. Engage the lever
before the leaving the forklift truck.
Caution
In the event of brake system failure or
an emergency, the lever can be engaged
for emergency braking. Do not use the
hand brake to slow down during normal
use.
Adjusting lever for steering wheel tilt angle [16]
The position of the steering wheel can be
adjusted. To perform adjustment, pull the
adjusting lever installed on the left side of the
steering hub column, move the steering wheel
to the desired position, and push down the
adjusting lever to lock.
Adjust the steering wheel tilt angle only
after the forklift truck has stopped and
the hand brake is engaged.
Forcibly move the steering wheel up
and down to ensure that it has been
locked after adjusting.
Direction lever [17]
The direction lever is installed on the left side
of the steering hub column. This series of
forklift trucks adopt electrical steering and the
functions realized by moving the lever forward
and backward are as follows:
(2WD rough terrain forklift truck)
Press the brake pedal to the bottom to fully
stop the truck before changing the driving
direction; push the lever forward to engage
forward gear I; pull up and push the lever
forward to engage forward gear II from gear I.
Press the brake pedal to slow down if it is
required to reverse; pull back the lever to
engage reverse gear I; pull up and push the
lever back to engage reverse gear II from
reverse gear I.
Caution
The engine can only be started when
To Next Page
Loading...
