There is an opening on the lower beam
of the fork arm carrier for loading and
unloading forks.
Do not use the fork in the open position
to prevent the fork from falling off from
the open position. Regularly check the
bolt in the middle of the fork arm,
which prevents the fork from being
used in the open position.
Step and handrail for getting on and off the
forklift truck
The body is provided with a step for getting on
and off on both sides; the handrails are
installed on the left and right pillars of the
overhead guard. Please use the handrails for
safety when getting on and off the forklift
truck.
Hydraulic oil tank lid
The hydraulic oil tank lid is on the right frame
of the internal combustion engine hood that
can be opened when refuelling. Replenish with
clean hydraulic oil through the oil filler and
screw the lid down after refuelling.
Fuel tank lid
Fuel tank lid with a lock
The fuel tank lid is on the left rear side of the
body. There is a vent in the fuel oil tank and
the vent should be checked for blockages
when refuelling.
Caution
When refuelling, the forklift truck must
be stopped, the engine must be shut
down, and the hand brake lever has to
be engaged; the driver must get off and
there should be no naked flames
nearby.
The lid must be screwed down after
refuelling; otherwise the fuel will leak,
which may result in a fire.
The engine can only be started after
wiping up the spilled fuel.
Naked flames are prohibited when
checking the fuel level.
Mirror
A mirror is installed on the upper right of the
overhead guard for observing conditions
behind the truck or when reversing.
Headlights
Headlight removal and installation
1
、
Remove the decorative frame.
2、 Unscrew the four screws on the back of
the headlight cover and remove it.
3、 Disconnect the headlight leads, loosen the
To Next Page
Loading...
