lock, remove the headlight, replace the bulb
with a new one and then fit the cover.
4
、
Loosen the two fixing screws of the LED
width light, remove it to check for any damage;
if it is damaged, cut the lead wire near the
soldering point, replace the panel with a new
one, re-solder it to its original position and
replace it.
5
、
Rotate in the opposite direction according
to the arrow on the back of the steering light,
take it out, replace with a new bulb and put it
back in.
6
、
Close its cover, screw on and finally install
the decorative frame.
Rear combination light
1-Steering light 2-Brake light/width light
3-Reverse light
Disassemble the rear combination light from
the overhead guard while taking care to ensure
your safety.
1
、
Take the whole combination light to the
maintenance site, remove the rear lampshade,
and unscrew the four mounting screws on the
back of the lamp housing.
2
、
Take out the panel, loosen the two screws
that fix the connector, detach the connector,
and replace with a new panel.
3、 The assembly steps are a reverse of the
disassembly ones.
To Next Page
Loading...
