maintenance and lubrication cycle, the
following parts should be lubricated regularly.
① The lubrication cycle should be adjusted
according to the operating conditions. In the
busy months of operation, the lubrication cycle
should be shortened.
② In order to ease the forklift operation,
apply a layer of grease to the contact surface of
the lifting guide wheel and the inner & outer
mast.
mast
Apply a layer of grease on the supporting guide
rails.
Warning
When applying grease, park the forklift
on a flat road, turn off the engine and
engage the hand brake. Prevent your
hands and body from being trapped
when applying grease, and take care not
to fall when lubricating at height.
Use a brush dipped in engine oil to lubricate
the chains on the left and right sides.
8. For the lubrication of the following parts, see
the Lubrication System Diagram for details.
① Lubrication of mast seat bearing;
② Lubrication of inching brake pedal;
③ Lubrication of steering axle support shaft;
④ Lubrication of steering knuckle spindle;
⑤ Lubrication of steering linkage pin;
⑥ Lubrication of steering cylinder pin.
9. Bolt and nut tightening
See maintenance cycle table.
10.Wheel nut torque check
Check whether the tightening torque of the
wheel nuts meets the requirements.
Front wheel
①Wheel nuts; ②Split rim bolts; ③Half shaft
bolts
To Next Page
Loading...
