to support the forklift are solid and
sufficiently strong.
When the forklift is supported with
wooden blocks only, do not lie
underneath it.
g
）
Put on the nuts in sequence as shown in the
diagram and lock them temporarily.
h
）
Remove the wooden blocks under the frame,
lower the forklift slowly to the ground and
remove the wooden blocks and jack behind
the front wheels.
i
）
Tighten the nuts to the specified torque in a
crosswise manner. Please refer to the
Tightening Torque Table.
j
）
Adjust the tire pressure to meet the specified
parameters.
3. Preparation for hot/cold conditions
Oil
Select oil with an appropriate viscosity for the
ambient temperature.
4. Clean the radiator fins
Warning
Airborne dust may get into your eyes,
so protective glasses or dust goggles
should be used.
If the radiator fins are blocked, it will cause
overheating, so compressed air, steam or water
should be used to clear the fins.
Caution
When using compressed air or steam to
clean the radiator fins, place the nozzle
at a right angle to the radiator.
5. Procedure for overheated engines
If the engine has overheated, do not stop the
engine immediately, and the following steps
should be taken:
a
）
Run the engine at low speed.
To Next Page
Loading...
