8. Fan cutting and clamping labels
9. Antifreeze label
11. Tie-down point label
12. Diesel label: Indicates that the oil filler is on
the left rear leg of the overhead guard.
13. Tonnage label
“30” indicates that the rated load capacity is
3.0t, but if the lift height is increased or there
are accessories, the rated load capacity will be
decreased.
15. Warning label
Do not load lift truck over capacity limit designated on the load chart.Do not lift unstable loads.
This lift truck is not designed for raising or transporting people.Do not use lift truck for those purposes under any
Before you get off lift truck,made sure the hand brake is set,lower forks or attachments,put forward/reverse lever
in neutral position and turn off key switch.Do not park on a slope.
circumstances.
Repair work should be done by authorized and trained persons only.
W A R N I N G
SERIOUS OR FATAL INJURY MAY RESULT TO YOURSELF OR OTHERS IF NOT FOLLOWED
This lift truck should not be operated by anyone who is not authorized and properly trained.
Read the Operators Manual and all warnings carefully,and make yourself familiar with your lift truck.
Inspect and check your lift truck daily before and after use.Do not operate faulty or damaged lift trucks.
To protect from falling objects,make sure that the Overhead Guard and Load Backrest Extension are correctly mounted
and in good condition.
Before starting engine,always set forward/reverse lever in neutral,with hand brake on .
Drive carefully,keeping forks and attachments as low as possible & fully tilted backp- Never Forward
Keep a careful lookout for people,obstructions and the path of travel.Watch clearance,especially overhead and tail
swing.Yield right of way to pedestrians.
Drive forward when you are climbing a slope with a load .Drive in reverse when you are descending with loads.Do not
Slow down before turning.Avoid any sudden start,stop or turning.Lateral tipover can occur if truck is improperly operated.
Do not stick hands,feel and other parts lf your body outside the Operators compartment.
Operator's Manual and Service Manual are supplied with this truck or available from our forklift truck dealers.
turn while on a slope.
Move the steering wheel forward and lean the
backrest forward before opening the engine
hood. Return the steering wheel and backrest
to original positions after closing the engine
hood.
17. Hand brake label
18. Control label 1 (hydraulic trucks only)
To Next Page
Loading...
