8
This indicates that the meter has lost its
configuration. Contact your dealer or the
nearest Hanna Customer Service Center.
ERROR MESSAGESERROR MESSAGES
ERROR MESSAGESERROR MESSAGES
ERROR MESSAGES
a) on zero reading:a) on zero reading:
a) on zero reading:a) on zero reading:
a) on zero reading:
The instrument cannot adjust the light
level. Please check that the sample does not
contain any debris.
There is not enough light to perform a
measurement. Please check the prepara-
tion of the zero cuvet.
This indicates that the zeroing procedure
failed due to a low signal-to-noise ratio. In
this case press ZERO again.
There is too much light to perform a
measurement. Please check the prepara-
tion of the zero cuvet.
The lamp is not working properly. Contact
your dealer or the nearest Hanna Customer
Service Center.
The lamp is not working properly. Contact
your dealer or the nearest Hanna Customer
Service Center.
Light over range. The cuvet is not inserted
correctly and an eccess ambient light is
reaching the detector. If the cuvet is
properly inserted, then contact your dealer
or the nearest Hanna Customer Service
Center.
To Next Page
Loading...
Need help?
General
