EasyManuals Logo

Hanna Instruments C 99 series User Manual

Hanna Instruments C 99 series
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
7
GUIDE TO DISPLAY CODESGUIDE TO DISPLAY CODES
GUIDE TO DISPLAY CODESGUIDE TO DISPLAY CODES
GUIDE TO DISPLAY CODES
Note: The secondary LCD below shows a generic "P– –", whereas the
meter will indicate the exact program number (e.g. in C 200,
"P1" for Aluminum).
Sampling in progress. This flashing
prompt appears each time the meter is
performing a measurement.
The microprocessor is adjusting the light
level, indicated by a scrolling "SIP".
This indicates that the meter is in a zeroed
state and measurement can be performed.
The blinking "LOBAT" indicates that the
battery voltage is getting low and the
batteries need to be replaced.
The light level is accepted. The instrument
is ready to perform a zero reading. This
flashing prompt will only appear when a
second zero reading needs to be performed.
Follow the measurement procedure de-
scribed in the related chapter.
The instrument is performing an internal
check-up.
This indicates that the meter is in a ready
state and zeroing can be performed.
This indicates that the batteries are dead
and must be replaced.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hanna Instruments C 99 series and is the answer not in the manual?

Hanna Instruments C 99 series Specifications

General IconGeneral
BrandHanna Instruments
ModelC 99 series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals