33 Channel
Manu item Screenshot Function
LOG RECALL
Access logged data and transfer files to USB stick
GENERAL
Configure or view general settings (e.g. log interval,
password, date and time, language selection, setting RS‑485
communication parameters, setting controller ID)
6. CHANNEL
When Channel is selected Disable (Enable), Setup, CAL virtual keys are visible.
• Press CAL to open the probe calibration menu
• Press Setup to open a process control submenu: Probe Settings, Control Settings, Alarm Settings
6.1. PROBE SETTINGS NAVIGATION
• Press the
m key from the Measure mode.
• Select Setup with Channel (1 or 2) highlighted.
• Select Setup with Probe Settings highlighted.
Enable
b
Setup
• Press the ud keys to navigate between parameters.
• Select from virtual keys View, Set, or Modify.
Press the
b (back) key to return to the menu without saving.
• At prompt, enter the passcode.
• At prompt, press YES, to place unit in HOLD.
Note: The controller validates the configured Setup when attempting to exit menu and directs the user to any
invalid parameters. At prompt to save changes, press virtual key YES.
To Next Page
Loading...
