47 Hold Mode
Hold Input
Hold mode can be triggered using external trigger inputs. This is a read‑only parameter that indicates what
Inputs are configured to initiate Hold mode. If an input is selected, the selected input is displayed.
• To change the input assignment for Hold Input, return to the top level Menu structure and select Inputs.
• To return to the menu without changing, press the
b key.
Hold Output
This is a read‑only parameter that indicates what relay outputs (if any) are configured to Hold mode. To return
to the menu without changing, press b key.
Hold Release Delay
Option: 0 to 99 seconds
Hold Release Delay is a timer that allows control function to remain in a HOLD state for additional time after
the HOLD is released. This time will be counted down and displayed on the Title & Status area.
With Hold Release Delay selected, press Set to modify.
At prompt, enter the passcode.
The time value flashes, indicating that it can be modified. Press the
ud keys to adjust the value.
Press CFM, to save or press the
b key, to return to the menu without saving.
Note: The controller validates the configured Setup when attempting to exit Menu and directs the user to any
invalid parameters. At prompt, to save changes, press YES.
To Next Page
Loading...
