Hanna Instruments HI520 - Page 69

69 Log Recall
Depending on the number of setup changes, users can access more than one screen by pressing the virtual
key for -->.
15.2.1.5. Probe specific, HI7640‑50 only
ODO Cap Error
HI520 Log Event Codes & Assigned Parameters
HI520 operates an event logging system whereby when setting new parameter values, a Setup event and event
code are generated. Log event stores the Setup event code and both new and previous values.
Code Setup Parameter
0 Key beep
1 LCD contrast
2 LCD backlight
3 Time format
4 Date format
5 Decimal point
6 Temperature unit
8 Log interval
9 Error beep
10 Language
11 Password enable
12 RS‑485 Address
13 RS‑485 Baud rate
14 Startup control delay
15 Remote control
16 Controller ID
17 Setup timeout
19 Password setup
20 Password remote
21 CH1 Set point 1 status
22 CH1 Set point 2 status
Code Setup Parameter
23 CH2 Set point 1 status
24 CH2 Set point 2 status
29 CH1 Set point 1 control mode
30 CH1 Set point 2 control mode
31 CH2 Set point 1 control mode
32 CH2 Set point 2 control mode
33 CH1 Set point 1 parameter
34 CH1 Set point 2 parameter
35 CH2 Set point 1 parameter
36 CH2 Set point 2 parameter
37 CH1 Set point 1 overtime
38 CH1 Set point 2 overtime
39 CH2 Set point 1 overtime
40 CH2 Set point 2 overtime
41 CH1 Set point 1 minimum on time
42 CH1 Set point 2 minimum on time
43 CH2 Set point 1 minimum on time
44 CH2 Set point 2 minimum on time
45 CH1 Set point 1 value
46 CH1 Set point 2 value
47 CH2 Set point 1 value