4 - Sprayer Setup
37
Hydraulic systems
General Info
Ensure that the snap couplers are clean before connection!
After having operated the boom and the system has been filled with oil, check the tractor’s hydraulic oil level and top up, if
necessary.
€
DANGER! Test of the hydraulic system should be done very cautiously. There may be air trapped in the system which
can cause violent movements of the boom.
€
DANGER! Hydraulic leaks: Never use your fingers to locate a leakage in any part of the hydraulic system. Due to high
pressure, hydraulic oil may penetrate the skin.
Requirements for Tractor
The hydraulic system requires:
• One double-acting outlet for the electro-hydraulic operation of the boom functions.
Models without electrical activated boom lift also require:
• One single-acting outlet to raise and lower the boom.
μ
ATTENTION! The hydraulic hoses are marked with arrows to indicate the direction of oil flow.
μ
ATTENTION! The hydraulic system requires an oil flow between 25 and 130 l/min and a minimum pressure of 180 bar.
±
WARNING! All hoses MUST be connected. Ensure snap couplers are thoroughly clean before connection. Failure to do
so will cause premature wear to the blower hydraulics.
Closed Centre Hydraulics
The sprayer is delivered for use with open centre hydraulic
systems. If the tractor is equipped with closed centre (load sensing)
hydraulics, the bypass on the hydraulic valve block on the sprayer
needs to be blocked off.
The sprayer is supplied
with an extra 1/2” brass nipple with no
perforation.
To convert the sprayer for closed centre hydraulics:
1. Disconnect hydraulic hose A
2. Swap standard 1/2” black nipple B with brass nipple C
3. Connect hydraulic hose A.
To Next Page
Loading...
Need help?
General
