6 - Maintenance
85
Horizontal Alignment of Center and Inner Sections
1. Loosen the nut (A).
2. Adjust the screw (B) with an Allen key. There should be 10 mm
thread visible on the outside of the nut (A).
3. Tighten the nut (A) against the plate again.
Horizontal Alignment of Inner and Outer Sections
μ
ATTENTION! This alignment must be done before attempting to
do the “Over-Centre Boom Lock Adjustment” on page 87.
÷
NOTE! This instruction applies for the connection between inner
and intermediate sections as well as for the connection between
intermediate and outer sections.
1. Loosen the lock nuts (A).
2. Adjust the screws (B).
3. Tighten the lock nuts (A).
4. Fold the boom to see if it hits and rests correctly in the transport
brackets.
To Next Page
Loading...
Need help?
General
