5 - Operation
104
MultiRinse
1. Go to AutoWash by pressing .
2. Press to enter MultiRinse.
3. Begin driving in the field just sprayed. Spray at half of normal
spraying speed, whereby dose rate (litres/ha) is increased.
4. Press to start the program.
5. In field (A), drive approximately 800 metres (4.5 km/h) at first cycle,
then further1700 metres (9 km/h) until MultiRinse has finished.
÷
NOTE! Driving speed reduction must be due to lower gear
selection to keep nominal PTO revolutions. The operator is given a warning in the controller display if the PTO
revolutions get to low or high for AutoWash to operate.
÷
NOTE! External fill hoses from injector to External filling coupler and to suction SmartValve is not flushed. This contains
approximately 8 litres.
The following diagram show the valve positions during the MultiRinse program.
11:58
12:58
13:58
14:58
15:58
17:58
18:58
28:58
21:58
22:58
23:58
24:58
25:58
27:58
31:58
32:58
38:58
33:58
34:58
35:58
37:58
41:58
42:58
43:58
44:58
45:58
47:58
48:58
58:58
51:58
52:58
53:58
54:58
55:58
57:58
Pre-start MainTank emptying
Pressure
SmartValve
Suction
SmartValve
Main
Spray
ON/OFF
CycloneFilter
Boost Line
Valve
Agitation
Valve
To Next Page
Loading...
