IMS-640/641 VoIP Intercom Master Station Operating Instructions MicroComm DXL
MN-DXL-IMS-640/641-1.0. Page 36
The screen on the right shows a typical Events List, with one of the
Alarms corresponding to a hardware fault (F) and two of the Alarms
corresponding to Intercom requests (I). If you select one of the Intercom
requests and press the Accept function key you will establish an audio
channel between your Master Station and the selected Station.
If you respond to a hardware fault alarm (F) by selecting the Alarm and
pressing the Accept function key the display will change as shown. You
can then press the Acknowledge function key and the fault will be moved
to the Acknowledge List (and turn off the reminder beep if it is the only
current unacknowledged alarm). If the fault has been repaired you press
the Cancel function key to cancel the alarm. This will remove it from all
lists. If the Event is generated from a switch you can disable the switch.
Any subsequent faults will not cause an alarm.
Selecting a Fault alarm.
Display showing Alarm List
F 102 East Door
Master Station # 20
Active Alarm
Cancel
0
0
12
Acknowledge
Disable
I 2010 Cell A103
Master Station # 20
I 2016 Cell A118
F 102 East Door
Cancel
0
0
12
Accept
Events :12
To Next Page
Loading...
Need help?
General