IMS-640/641 VoIP Intercom Master Station Operating Instructions MicroComm DXL
MN-DXL-IMS-640/641-1.0. Page 28
The display will now change with the Enable function key will now
displayed.
Enabling Call Request Switch from the Disabled list
A second method of enabling a disabled station is to display the
Disabled list.
Selecting the Control function key from the “Idle menu” will bring
up a new menu. Selecting the Disabled function key on the new menu
will bring up the disabled list. Scroll to the station you wish to Enable
and select the Accept function key to change to the selected station to
an enabled state
Enabling/Disabling Tamper Alarm at an Intercom Station
The Tamper Alarm switch can be Enabled/Disabled following the same procedure used to Enable/Disable the Call
Request switch.
Enabling/Disabling Music at an Intercom Station
The Music switch can be Enabled/Disabled following the same procedure used to Enable/Disable the Call
Request switch.
Setting the Audio Level Alarm Thresholds for an Intercom Station
The audio level alarm setting at as is station is Enabled/Disabled using a similar procedure to that used to
Enable/Disable the Call Request switch. The main difference is that when a station’s audio level alarm is enabled
it can be set to one of four possible predefined ALA filter settings.
The Call Request Switch at Station #2001
can be Enabled
2002
Housing1Exit
Master Station #20
2003 UnitAEntry
2001 Housing1Entry
Enable
0
0
0
Cancel
Hit Accept to Enable
Master Station #20
Accept
1
I 2001 Housing1Entry
0
0
To Next Page
Loading...
Need help?
General