Page 50
CDi DriveCore Series Operation Manual
Using HiQnet Audio Architect
5� Double-click the amp image to open the Main CDi DriveCore Control panel.
6� Click on one of the Input buttons.
7� Click on Triggered Source Selects.
8� The Triggered Source Selects panel provides an easier, more efficient method for programming a Contrio wall controller to control input source
selection of a CDi DriveCore amp. There are four different source selection states: Trigger A–Trigger D. The input channels are displayed along the top
(4-channel amp model shown). Type a user label for each triggered state—these labels will be displayed on the Contrio controller's screen. Check the
Include checkbox for each input channel that should be affected when recalling each triggered state. Set the desired input source and level for each
input for each triggered state. Leave this panel open, close other open panels, then proceed to the next step.
9� Go back to the Room window and double-click the Contrio Wall Controller image to open the Contrio Wall Controller window.
To Next Page
Loading...
Need help?
General