Constellation® January 2006
Index-2
dispersive fade margin, Receiver 4-11
dry relay contacts 4-18
DS3-to-DS3 interface, number of hops 3-2
DTMF receiver decoder 5-5
DVA 5-7
DVS II
orderwire 5-5
orderwire interconnection 5-2
dynamic range, Receiver 7-17
E
earthquake standards 4-19
electromagnetic emissions 4-19
emission limitations 4-10
environmental specifications 4-19
equipment transmission delay time 4-14
Errored Seconds alarm 4-18
Ethernet port
Constellation 4-16
, 5-8
ETS 300 826 4-19
External Alarm/Control connector 4-18
F
FarScan 3-4
connection 4-16
FCC 4-10
, 4-19
feeder, antenna 2-2
flange specifications 6-1
four-wire VF orderwire interface 5-4
four-wire VF specifications 5-4
frequency bands 2-1
frequency spacing
1+1 2-1
frequency stability
Receiver 4-10
Transmitter 4-10
full duplex 5-5
fuse panel 4-2
G
GlobeStar 5-7
glossary B-1
H
half-duplex communications 5-5
High Level Mux
repeater configuration 3-12
source timing mode 3-12
terminal configuration 3-12
through timing mode 3-12
HLM. See High Level Mux.
HLM-155 compatibility 3-2
hops, DS3-to-DS3 3-2
hot-standby
protection 4-15
humidity 4-19
I
image rejection, Receiver 4-10
input noise level 4-2
interconnection
SCAN and Constellation 5-7
Service Channel and Constellation 5-1
interfaces
network management 4-16
supervisory 4-16
intermodulation frequency products 2-2
intermodulation products, 1+1 2-2
ISO 9001 ii-ix
ITU-T 4-12
J
jitter
tributary 4-12
To Next Page
Loading...
