EN
Instructions for use for the user p. 41/48
11.2. Accessing user programs
1. Turn the function selector 2 to position G (user programs).
► The user symbol lights up.
2. Use the intensity selector 3 to select a user program (1–5).
3. Press the intensity selector 3.
► The user program is started.
► The intensity selector 3 lights up.
11.3. Creating your own user programs
You can create user programs as you would like. A preset user program is over-
written in the process. Perform the following steps:
1. Start all functions that are to be switched on with the user program with the
preferred intensity.
2. Turn the function selector 2 to position G (user programs).
► The user symbol lights up.
3. Use the intensity selector 3 to select which number (1–5) under which the
new user program is to be saved.
4. Press the intensity selector 3 for one second.
► The intensity selector ashes.
► The settings are stored in the selected user program.
To Next Page
