79
CONTENTS
CFV 100C
User Manual
Exposure Bracketing
The camera will automatically make a pre-determined number of exposures with a preset
exposure adjustment difference between each frame.
Amount: How much exposure difference between each exposure.
Frames: The number of exposures in the sequence.
Initial Delay: A delay between shutter release and first exposure.
Param in M: Which of aperture or shutter speed to change if exposure bracketing is used in
Manual Exposure Mode.
Sequence: The order to change the exposure compensation for each frame.
When Finished: Determines if the function shall be active after a completed cycle or not.
Configure exposure bracketing parameters and press the shutter release button to start
exposure bracketing. If Initial Delay is set, the camera will start a countdown before shooting
the first image. Shooting will start after the preset delay ends.
The touch display will show information such as exposure compensation and shot frames/
total frames during the sequence. Press the delete button to exit exposure bracketing if it is
required to exit before completed.
• Live View and Image Browsing are disabled after the exposure bracket starts.
• Light metering, focusing, and Auto WB is performed before the first exposure and applied
to all images in sequence.
• When the shutter speed is set to 16s or more, the camera will turn off the display to save
battery 5 seconds after shooting starts. The display will light up automatically before the
next image is shot. Users can also wake up the display by pressing the ON/OFF button.
• Exposure bracketing on the camera is disabled when the camera is connected to the
Phocus software on the computer or the Phocus Mobile 2 app on a mobile device. In this
case, use the capture sequencer in Phocus to achieve exposure bracketing.
80%
200
5.6 90
f/
EV
+1.512.0
+0.7
CFe
SSD
ISO
Drive Mode
Single
Continuous
Self-Timer Interval
Parameter in M
S
Sequence
0, +, -
When Finished
Exit
Amount
1/2
Initial Delay
None
Frames
3
Exposure Bracketing
Exposure
Bracketing